58
5. Slide the edge guides against the edges of the widest original.
6. If necessary during scanning, adjust the position of the stopper on the output tray extension to fit the
ejected originals.
Note: If thicker paper does not eject properly or falls from the output tray, push in the output tray and
allow the originals to eject freely onto the surface below the scanner. If the scanned images are
affected by the originals ejecting below the scanner, try placing the scanner on the edge of a table
where the ejected originals can drop freely.
If scanning thin or wrinkled paper causes paper jams, slow down the feeding speed by selecting the
icon or Settings > Scanner Settings > Slow > On on the LCD screen.
Parent topic: Loading Originals in the Input Tray
Related references
Suggested Tray Positions
Feed Selector Lever
Original Document Specifications
Original Document Specifications
You can load original documents that meet these specifications in your scanner.
DS-30000/DS-32000 (Normal Mode)
Note: The following table lists the capacity when the scanner is in Normal Mode and the feed selector
position is in the (DS-30000) or (DS-32000) position. If the feed selector is in the position,
originals should be manually fed one at a time.
To Next Page
Loading...
