B
Cover open lever Pull the lever and open the scanner cover.
C
Separation Roller Feeds originals separately one by one. This needs to be replaced
when the number of scans exceeds the service life capacity.
D
Pickup Roller Feeds originals. This needs to be replaced when the number of
scans exceeds the service life capacity.
E
Photoelectric device (glass surface) This sensor reads originals. Be careful to keep it clean.
F
Antistatic brush Brush that eliminates static electricity from originals. Be careful not
to touch it. If the brush becomes bent, it cannot eliminate static
electricity, and this may cause the ejected originals to stick to each
other.
Related Information
& “Cleaning Inside the Scanner” on page 119
& “Replacing the Roller” on page 124
Feed selector
Changes the position of the feed selector according to the type of the originals to be scanned.
Delicate Feed Feeds while adjusting the force to more carefully separate multiple sheets of
originals.
Allows scanning delicate originals such as thin paper (extremely thin paper)
by batch.
Normal Feed Normally set the selector to this position.
Plain papers, Envelopes, plastic cards (without embossing), and Carrier Sheet
can be fed.
Scanner Basics
>
Feed selector
16
To Next Page
Loading...
Need help?
General