Epygi QX50 User Manual

QX50/QX200/QX2000; (SW Version 6.0.x) 47
QX50/QX200/QX2000 Manual II: Administrator’s Guide
• No Action the Auto Attendant will continue to play the Recurring message (if configured) of the current menu.
• Go to the following menu will go to the specified submenu and take actions defined in that submenu. The drop down list allows the selection
of a previously created submenu or to create a new submenu by choosing the Create New Submenu item. The New submenu name text field
requires the new submenu name.
• Call To the following extension will call to the extension number specified in the extensions drop-down list.
• Call to the following number will call the specified phone number via the Call Routing Table.
• Call to the number dialed will send the user inputs to Call Routing table and if there is a matching with any Call Routing rule the call will be
made with the conditions of Call Routing rule (available only in case when the Any input other than in the list above input is edited).
• Invoke Extensions Directory will connect the caller to Extensions Directory.
• Terminate the call will exit from this Customized Scenario and disconnect the call.
The following options can be configured too:
• Any input other than in the list above - allows configuring the action taken when the caller makes a selection other than options listed in the
User Input table. If it is configured to No Action then the timer for No Input will reset and it will be counting the No Input time again.
• No input – allows configuring the action taken when the caller doesn’t enter anything during the certain period. The No Input timeout is equal
to [Welcome message duration] + Delay after message + [Recurring message duration] * Play Count + Play Count * Interval. If there is no input
during that time, the action specified for No input will take effect.
The Dial Timeout specifies the period of time to determine when the user has completed dialing and to begin to process the call. The timer will start after
the last digit or symbol is entered. If the (#) key has been pressed then the call will be processed immediately.
Incorrect number handling link opens the Edit Incorrect Number Handling page which is similar to Edit Option page to configure the action taken
when the user has selected a destination that resulted in a failed call, such as an invalid extension number.
Incorrect number handling link will open the page to configure the action taken when the user has selected a destination that resulted in a failed call,
such as an invalid extension number.
Please Note: The Incorrect number handling will be activated only in the following two cases:
• An attempt was made to call a non-existent extension,
• An attempt was made to call a number not matching with any "Destination Number Pattern" in the Call Routing table.
Attention: If a file with the same name is uploaded for other options, the previous file will be replaced.

Epygi QX50 Specifications

General

Brand	Epygi
Model	QX50
Category	Network Hardware
Language	English