7 • Service programs
26 / 56
80116-261
2018-07
Description of service programs
Service program S1 Flow test
Description
The S1 service program is used to check the flow of irrigation liquid over a
period of 1
minute at a flow setting of 100 %.
If the service program ends successfully, the message "CS1" (Complete
Service Program
1) is output on the display. If a fault occurs during execu-
tion, the message "ES1" (Error Service Program 1) is displayed.
Both messages can be canceled by pressing the activation button.
If a fault occurs during execution, its cause can be localized in operating
mode. To do this, abort the service program. The unit then automatically
switches to operating mode and the display shows an error message.
Run time
1 minute.
Set value
Fixed at 100 %.
To activate the service program
Press the activation button.
To abort the service program
Press quick activation button III.
To Next Page
Loading...
Need help?
General
