43 / 56
10 • Replacing components
80116-261
2018-07
Change gear motor
11. Undo screws on the gear motor (4) and remove the gear motor to the
rear.
12. Fit a new gear motor in reverse order.
13. Fit front frame in reverse order.
14. Close housing cover.
ATTENTION! Check line voltage setting
The EIP 2 can be operated on a line voltage of 230 V, 120 V, or 100 V.
Therefore, every time the unit is opened always check afterwards
whether the correct line voltage ±10
% is set on the line voltage selec-
tor switch on the main board.
To Next Page
Loading...
