To Next Page

To Previous Page

EASY-ROTOR-CONTROL M V2.2 Instructions

___________________________________________________________________________

Tannenstr. 16 Page 17 of 44 email : erc@schmidt-alba.de

86836 Untermeitingen / Germany

This document is for the user only. Any publishing (printed or in electronic form) is not allowed.

2.5 Insert ICs

The pins of the ICs have to bend before you can put them into

their sockets. Use a hard base (e.g. your working desk) and

bend the row of pins slightly, that they get an angle of 90°.

Now insert the ICs and take care about direction of the components

and not to bend any pins while inserting the components into the

sockets.

Questions and Answers:

Need help?

Do you have a question about the erc EASY-ROTOR-CONTROL M and is the answer not in the manual?

erc EASY-ROTOR-CONTROL M Specifications

General