To Next Page

To Previous Page

EASY-ROTOR-CONTROL M V2.2 Instructions

___________________________________________________________________________

Tannenstr. 16 Page 31 of 44 email : erc@schmidt-alba.de

86836 Untermeitingen / Germany

This document is for the user only. Any publishing (printed or in electronic form) is not allowed.

6.3 Assembly of top-side HID-PCB AZ/AZ (dual azimuth)

If your housing is AZ/EL (azimuth and elevation) proceed with step 6.4

First assemble the LCD with the 5mm spacers, screws, nuts and spring-washers to the PCB. Put the

16-pole pin-header between PCB and LCD before mounting. Leave the protection-foil on the LCD until

the HID will be mounted into the housing.

Now solder the 16-pole pin-header first to the LCD and than to the PCB.

This is how it should look like:

Please read the following instructions before you proceed:

LEDs:

Take care of polarization of the following components :

- LED5,LED6,LED7,LED8,LED9,LED10

Those components are marked red in the following drawing.

Assemble and solder the switches and LEDs according to the drawings.

Take care that the switches fit plane to the PCB. Otherwise you will have problems with sticky

switches later when the HID is mounted to the front-panel.

long leg

short leg

flat side

round side

Questions and Answers:

Need help?

Do you have a question about the erc EASY-ROTOR-CONTROL M and is the answer not in the manual?

erc EASY-ROTOR-CONTROL M Specifications

General