EASY-ROTOR-CONTROL M V2.2 Instructions
___________________________________________________________________________
© Ing.-Büro E. Alba de Schmidt web : www.schmidt-alba.de
Tannenstr. 16 Page 27 of 44 email : erc@schmidt-alba.de
86836 Untermeitingen / Germany
This document is for the user only. Any publishing (printed or in electronic form) is not allowed.
all values in mm (milli-meter)
First drill the centre-hole (10mm) and than the smaller holes.
Take care, that the bottom-side of the rotor-card has at least a distance of 8mm to
the housing. This is very important to keep the safety-distances, especially when the rotor-
card is carrying main-voltage (e.g. the brake-circuit of a HAM-IV).
Mount the rotor-card to the control-box using the 2 screws and spring-washers below the screws.
The wiring of the rotor-card to the different control-boxes is shown in the Installation-Guide provided
on the CD of your ERC-M-kit.
To Next Page
Loading...