09/2022 1028657-00A Installation instructions – 17/58
5 Dismantling
This section describes the steps for dismantling in detail. At
least one fitter and three helpers are required for the disman-
tling.
ESD-sensitive components!
Circuit boards and electric, electronic or
optoelectronic components are sensitive to elec-
trostatic discharge and may be destroyed when
touched.
To avoid this:
– Wear special ESD shoes.
– Always wear a grounded wristband as shown
below when working near electric, electronic
or optoelectronic components.
Before you touch any electric/electronic parts:
– Put the wristband on and ground according to manufactur-
er’s instructions.
Before the dismantling can begin, the canopy transport locks
must be released.
To Next Page
Loading...
