Clarity Edge Install Guide
•
•
•
•
•
•
•
According to the power supply logic designed for the system, when the device is powered by OBD, it
is powered when the vehicle is moving (G-sensor acceleration value > 10 g). If the OBD is installed
under normal power supply, shake the power box slightly.
Device Networking Failure after Startup
Make sure that the SIM card is inserted before device startup. If it is inserted after device startup, please
power off and restart the device.
Check whether the SIM card is installed correctly.
Check whether the network signal at the current position is good.
Check the traffic condition of the SIM card.
Device Recording Failure after Startup
Make sure that the SD card is inserted before device startup. If it is inserted after device startup,
please power off and restart the device.
Check whether the SD card is installed correctly.
After the SD card is inserted into the device, format it before use.
To Next Page
Loading...