Clarity Edge Install Guide
Health & Safety
Installation in or on water-borne equipment is not recommended and is not covered by EROAD's warranty.
This device is factory-sealed; tampering will void the warranty.
EROAD expects installers and contractors to understand and follow all relevant health and safety regulatory
requirements.
The Installer must wear appropriate Personal Protective Equipment (PPE) for the install risk and customer
requirements. PPE may include safety glasses, safety shoes, work gloves, hard hat, high visibility vest, sun
cream, sun hat and coveralls. The Installer must understand and comply with the safety requirements of
customers or third parties.
Avoid fitting EROAD-supported equipment in locations that could impede or cause injury to people. This
includes potential head strike zones on the windshield or dashboard, airbag deployment locations, seatbelts,
and other safety-relevant devices.
The vehicle must be parked and level, with the parking brake engaged.
Before installation, check that other safety-relevant equipment is working properly and report any issues to
the customer.
Before the Installer is permitted to work under or around suspended equipment – held aloft with slings,
hoists, or jacks – ensure the equipment is secured to prevent collapse or falls. Secondary controls should be
in place; working under a suspended load should be avoided.
Avoid running cables close to heat sources, sharp edges, obstacles or safety-relevant devices.
After installation, check that all other safety-relevant equipment continues to work properly.
While EROAD-supported devices are comprehensively tested against corrosion and ingress, devices are not
invulnerable to water, fire or impact damage, and certain devices are not able to be environmentally shielded.
Do not subject EROAD-supported devices to extreme heat, high-pressure water force or other intense
physical forces. Operating temperatures for the equipment related to this guide are found in the
specifications.
The Installer must ensure they fully understand these instructions before installing an EROAD-supported
device and immediately seek advice from a Regional Installation Manager on any matter that is not
understood.
To Next Page
Loading...