© ESAB AB 2010
-16-
bp12a1
Read and understand the instruction manual
before installing or operating.
This product is solely intended for plasma cutting. Any other use may result in
personal injury and / or equipment damage.
5 INTRODUCTION
The EPP power source is designed for marking and high speed plasma mechanized
cutting applications. It can be used with other ESAB products such as the PT-15,
PT-19XLS, PT-600 and PT-36 torches along with the Smart Flow II, a computerized
gas regulation and switching system.
5.1 Features
S 10 to 36 amperes for marking
S 30 to 360 amperes cutting current range
S Forced air cooled
S Solid state DC power
S Input voltage protection
S Local or remote front panel control
S Thermal switch protection for main transformer and power semiconductor
components
S Top lifting eyes or base forklift clearance for transport
S Parallel supplemental power source capabilities to e xtend curr ent output range
To Next Page
Loading...
