ESAB EPP-360 User Manual

-2-
TOCa
Rights reserved to alter specifications without notice.
1 USER RESPONSIBILITY 4............................................
2 SAFETY PRECAUTIONS - English 4...................................
3 PRECAUCION DE SEGURIDAD - Spanish 8............................
4 MESURES DE SECURITE - French 12..................................
5 INTRODUCTION 16...................................................
5.1 Features 16.................................................................
6 TECHNICAL DATA 17.................................................
7 INSTALLATION 17....................................................
7.1 General 17..................................................................
7.2 Unpacking 17................................................................
7.3 Placement 18................................................................
7.4 Input power connection 18.....................................................
7.4.1 Primary power 18........................................................
7.4.2 Input conductors 19......................................................
7.4.3 Input connection procedure 19............................................
7.5 Output connections 20........................................................
7.5.1 Output cables (customer supplied) 20......................................
7.5.2 Output connection procedure 20...........................................
7.6 Parallel installation 21.........................................................
7.6.1 Connections for Two EPP -360’s in parallel 21...............................
7.6.2 Marking with two parallel EPP -360’s 23....................................
7.7 Interface cable connectors 24..................................................
7.7.1 CNC interface cables with mating power source connector and unterminated CNC inter-
face 24.................................................................
7.7.2 CNC interface cables with mating power source connectors at both ends 25.....
7.7.3 Water cooler interface cables with mating power source connectors at both ends . .
25
7.7.4 Power source parallel control cable 26......................................
8 OPERATION 27.......................................................
8.1 EPP-360 Block Diagram 27...............................................
8.2 Control panel 28.............................................................
8.3 Modes of operation 30........................................................
8.3.1 4.3.1. Single power source (used with the CNC, two basic modes of operation are pos-
sible) 30................................................................
8.3.2 Multiple power sources 33................................................
8.4 Sequence of operation 33.....................................................
9 MAINTENANCE 34....................................................
9.1 General 34..................................................................
9.2 Cleaning 34.................................................................
10 TROUBLESHOOTING 35..............................................
10.1 Troubleshooting guide 35......................................................
10.2 Help code list 36.............................................................
10.3 Fault Isolation 37.............................................................
10.3.1 Fans not working 37.....................................................
10.3.2 Torch will not fire 37.....................................................
11 REPLACEMENT PARTS 38............................................
11.1 General 38..................................................................
11.2 Ordering 38.................................................................

ESAB EPP-360 Specifications

General

Brand	ESAB
Model	EPP-360
Category	Welding System
Language	English