ESAB MXH 315 PP - Installing or Changing the Wire Guide in the Torch Neck

DOKP4M4060 3.0 -14- © ESAB/TBi 2021
3.3.5 Installing or changing the wire guide in the torch neck
The wire guide must be selected to match the material and diameter of the welding wire; always use the
complete equipment kit according to the following table.
Table 2: Equipment kits for torch neck
Welding wire
Equipment kit
part no.
Wire diameter
[mm]
Material of the wire guide
(J)
Length
[mm]
Inlet guide (102)
Part no.
AIMg, AlSi,
CuSi, fill wire,
stainless steel
0700 025 313
0.8 - 1.0
PA/ Bronze liner
(110)
320
0700 025 321
0700 025 314
1.2
PA/ Bronze liner
(110)
320
0700 025 322
0700 025 315
1.6
PA/ Bronze liner
(110 A)
320
0700 025 323
Steel
0700 025 316
0.8 - 1.0
Insulated liners, blue
(111)
320
0700 025 324
0700 025 317
1.2
Insulated liners, red (111)
320
0700 025 325
0700 025 318
1.6
Insulated liners, yellow
(111 A)
320
0700 025 323
Wire guides in bold = standard version