DOKP4M4060 3.0 -20- © ESAB/TBi 2021
4.2 What to do in case of faults or maintenance
Danger!
Please observe the safety instructions at the beginning of this manual!
Damaged torches or cable assemblies must not be used anymore!
Known defects must be repaired prior to the next use of the equipment
Danger of burn injuries!
Gas nozzle and torch head get very hot during welding. Let the torch cool down prior to
doing maintenance work!!
For safety reasons the following sequence is to be strictly followed:
1. Before performing maintenance on the system, the main power of the installation must be turned off.
2. Let the torch cool down prior to doing maintenance work (e.g. replacing wear parts)!
3. Eliminate fault (see section 7) or perform maintenance (see section 5)
4. Turn on the main power of the installation.
5. If necessary, perform the wire run-in. (see section 4.3)
6. The ESAB MXH PP welding torch is now ready for operation.
4.3 Wire run-in
To Next Page
Loading...
