DOKP4M4060 3.0 -6- © ESAB/TBi 2021
1.4 Warranty
Before delivery, our products are carefully checked. We guarantee, that each product is free from defects of
material and workmanship at the time of delivery and is functioning according to its intended use.
ESAB provides warranty on defects of material and workmanship according to legal requirements. Wearing
parts are exempt from this warranty.
The warranty does not cover any damages or functional deficiencies resulting from
▪ overloading, abusing or non-intended use of the product
▪ accidents
▪ noncompliance with indications stated in these operating instructions
▪ improper installation or assembly
▪ insufficient maintenance
▪ modifying the product from its original state
▪ chemical influences
▪ normal wear and tear during proper operation
ESAB assumes no liability other than for replacement or repair of faulty parts.
2 Product description, Technical data
2.1 General area of application and functions
2.1.1 Area of application
ESAB MXH PP-TX welding torches were developed as an easy way to upgrade ESAB MIG/MAG welding power
sources into a high-performance Push-Pull system.
Considerably longer cable assemblies can be used with the Push-Pull torch. Wires that are difficult to handle
e.g. AlMg wires can be easily fed over distances of up to 10.5 m through the additional wire feed system in the
torch handle. The welding process remains stable due to the even wire feed speed.
The powerful wire feed with large feed roll provides optimal performance whilst protecting the wire.
ESAB MXH PP-TX welding torches are equipped with easily changeable torch necks. Thus, the torch can be
optimally adjusted to changing tasks. Even in the event of a faulty neck, work can continue immediately with a
spare neck.
The neck can also rotate in the holder. This also makes many tasks easier.
The handle was manufactured using 2-component technology and provides an appealing, ergonomic shape
with optimized non-slip properties. The drive mechanism is easily accessible thanks to the large cover. The
contact force of the feed roll can be adjusted over a wide range.
2.1.2 Function
The wire feeding system integrated into the handle of the ESAB MXH PP-TX torch supports the main feed unit
of the power source for the wire feed. Therefore, the friction of the wire in the cable assemble no longer has a
direct impact on the wire speed, the wire is fed at a consistent speed.
In the drive unit, the wire is pressed into the groove of the driven feed roll by a smooth pressure roll. A high
feeding force can thereby be transferred without deformation of the wire.
To Next Page
Loading...
