Estun E200P - 3.6 Alarm and Monitor

E200P Operation Manual
15
PROGRAM2 1
/ 3ST
:
X= 10.00 Y = 10.00
XP: 50.00 mm
YP: 85.00 mm
DX: 50.00 mm
OPEN DIST: 0.00 mm
Repeat Times: 1 TIMES
Figure 3-5 The STEP page
The description of STEP parameters is as shown in Table 3-3.
Table 3-3 The description of Step parameters
Parameter Default Range Unit Description
XP
0.00
0~9999.999
mm/inch
Program position of X-axis.
YP
0.00
0~9999.999
mm/inch
Program position of Y-axis.
DX
0.00
0~9999.999
mm/inch
Retract distance of X axle.
OPEN DIST 0.00 0~999.999 mm/inch
After bending, the distance of the
Y-axis opening.
Repeat Times
1
1~99
-
The repeat times in this step.
Step 5 After finishing operation, you can accord the actual situation to run the machine.
- If you want to run the machine from a certain step, press arrow key to switch
that step page, Press to run, the device enters RUN page.
- If you want to run the machine in in sequence, press back to PROGRAM
page, and then Press to run, the device enters RUN page.
----End