Estun E21 - Page 21

E21 Installation Manual
18
Name
Default value
Range
Description
Repeat Enable
0
1~99999999

0:disable

1:enable
Repeat Time
0.5
0~99.99s
Interval of back gauge
reposition when repeat
position
Mute Dis.
10
0~9999.999mm
Conversion distance between
high speed and low speed.
Motor lowers speed when
enter this range.
Stop Time
0.5
0~99.99s
Back gauge reaches advance
stop range. Due to inertia,
back gauge will not stop
immediately after motor stops.
The time for back gauge to
stop.
OT Time
0.5
0~99.99s
Interval between back gauge
reach over travel position and
input motor signal.
Drive Mode
1
0 or 1

0: common motor

1: single-frequency
converter
High freq.
100%
0~100
Frequency percent in the
high-speed mode. This value
is valid only when X drive
mode is set to frequency
converter.
High frequency = this value
× the fixed frequency
In general, the fixed frequency
is 50Hz.