ETAS ES4440.2 - Page 39

ES4440.2 Compact Failure Simulation Module - User’s Guide 39
ETAS Pin Assignment
e n.c. n.c.
f n.c. n.c.
g n.c. n.c.
h n.c. n.c.
j n.c. n.c.
k n.c. n.c.
l n.c. n.c.
m n.c. n.c.
n n.c. n.c.
p n.c. n.c.
r n.c. n.c.
s n.c. n.c.
t n.c. n.c.
u n.c. n.c.
v n.c. n.c.
w n.c. n.c.
y n.c. n.c.
* The lines of the signals ”ECU60”, ”ECU61” (pins U,V) and ”ECU62”,
”ECU63” (pins W,Y) are routed to ”LOAD CH43-CH63” as ”twisted pairs”.
Together with the two ”Shield” lines (pins Z and a), these are thus suitable to
be used as CAN lines, but can also be used as normal channels.
Pin Signal Internally Connected to Connector
”LOAD CH43-CH63” - Pin:
Tab. 3-8 ”ECU CH43-CH63” Pin Assignment (Forts.)