ETAS ES592.1 - Supported Applications and Software Requirements

ETAS Technical Data
ES592.1 - User Guide 46
To deactivate the power saving mode
Choose in System Control Center / Device Manager / Network Adapter the
used network adapter by double-click. Deactivate the "Allow the computer to
turn off this device to save power" option in the "Power Management" register.
Confirm your configuration.
The manufacturers of network adapter have different names for this function.
Example:
• “Link down Power saving”
• "Allow the computer to turn off this device to save power"
8.8.2 Supported Applications and Software Requirements
To configure the ES592.1 and for control and data acquisition, you need soft-
ware in the following versions:
Support in
Application Software
Inter
-
face
Application Classifi
-
cation
1)
INCA V6.2.1
2)
INCA V7.0
3)
ETH XCP on Ethernet MC yes yes
ETK ETK
Measurement and
Calibration
MC yes
4)
yes
5)
CAN CAN Monitoring MC yes yes
CAN Output MC yes yes
CCP MC yes yes
KWP on CAN MC yes yes
UDS MC yes yes
XCP on CAN MC yes yes
LIN LIN Monitoring MC yes
6)
yes
7)
1)
: MC: Measurement and Calibration
2)
: INCA V6.2.1 with Hotfix 13 and higher and additionally INCA-ES5xx Add-On
V6.2.2 and higher
3)
: additionally INCA-ES5xx Add-On V7.0.0 and higher
4)
: additionally ETK Drivers and Tools V2.1.6 and higher
5)
: additionally ETK Drivers and Tools V3.0.0 and higher
6)
: additionally INCA-LIN Add-On V6.2.3 and higher
7)
: additionally INCA-LIN Add-On V7.0.0 and higher