20 OneTrack and OneTrack Backbone Planning and Installation Manual
Cable Mounting (OneTrack Only)
CAUTION: All hardware for attaching wire rope or threaded rod to
appropriate building structure is the responsibility of the installing
contractor.
• Standard kits are available for suspension-mounting OneTrack with 1/16in (1.5 mm)
aircraft cables. See
Five-inch Support Feed Kit on page 46
and
Five-inch Support Kit on
page 47
.
• Additional track accessories are required for suspension-mounting OneTrack. See
OneTrack Mounting Accessories on page 44
.
• Be sure to consider track stability in suspension-mounting applications. Vibrations caused
by HVAC operation and other building systems could impact the function of the track
system.
Threaded Rod Mounting
When mounting OneTrack with threaded rod, either 5/8inch threaded rod or 3/8inch IPS is
recommended.
OneTrack Backbone provides a standard Unistrut profile on its top surface. Use standard
Unistrut hardware and threaded rod to mount OneTrack Backbone.
Other Mounting Options (OneTrack Backbone Only)
In addition to threaded rod mounting, OneTrack Backbone can also be attached directly to
building structure using standard Unistrut beam clamps and hardware or to other U-channel
products using standard hardware.
To Next Page
Loading...