Introduction 1
Introduction
About OneTrack by ETC
The OneTrack by ETC system provides two independently controlled power circuits with an
integrated DMX/RDM data bus in a professional-grade aluminum extrusion. OneTrack can be
used with phase-dimmed and low-voltage controlled luminaires.
OneTrack easily blends into its surroundings, providing power and data reliably and discretely.
It's the solution for a variety of applications, including art galleries, museums, retail displays,
lobbies, comedy clubs, nightclubs, and hotel ballrooms.
The OneTrack by ETC system includes an extensive selection of adapters, feeds, end caps,
couplers, hanging accessories, and other accessories to meet most installation requirements.
OneTrack supports:
• Two 20 A circuits with separate neutrals
• Up to 32 DMX devices per data run
• Up to 20 RDM devices per data run
• Cable mounting, threaded rod mounting, or surface mounting, including vertical or
horizontal wall mounting (recessed mounting also available; contact your local ETC
representative for more information)
• 3A, 5A, 8A, and 12A current-limiting breakers located directly at the track
• Supports up to 55 lb (25 kg) of attached luminaires when support on 3 ft (900 mm)
centers, or 110 lb (50 kg) when support on 18 in (450 mm) centers
• Two-year warranty
• White and black finishes
• 4 ft, 8 ft, and 12 ft (1.21 m, 2.43 m, and 3.65 m) sections that can be field-cut to custom
lengths as required
Note:
OneTrack by ETC utilizes components from the A.A.G. Stucchi ONETRACK
®
UL line of products. For additional components outside of the OneTrack by
ETCoffering, visit www.aagstucchi.it.
To Next Page
Loading...