ETC OneTrack by ETC - End of Track Installation; Installing End Feeds

Preparing for Installation 21
End of Track
The end of OneTrack must be enclosed with a OneTrack end cap (part number 7076A1023).
If you are using OneTrack Backbone, you must still enclose the end with the OneTrack end cap
(as shown in the figure below), but you can also optionally install a OneTrack Backbone end
cap (part number 7076A2017) for cosmetic purposes. Because the ends of OneTrack and
OneTrack Backbone should be flush, the OneTrack end cap extends beyond the end of
OneTrack Backbone. The OneTrack Backbone end cap encloses the OneTrack end cap.
OneTrack
end cap is
always required
OneTrack
Backbone end
cap is optional
OneTrack end cap extends beyond the
end of OneTrack Backbone. Optional
OneTrack Backbone end cap covers it.
Figure 20: End caps