AUDIO | VIDEO MEDIA CONTROLLERS
EuCon APPLICATION SETUP GUIDE
FINAL CUT PRO
10
Section 3: Final Cut Pro
Configuring Final Cut Pro to operate with the Artist media controllers is simple.
1. In Final Cut Pro, choose Tools->Control Surfaces.
The Control Surface Configuration dialog opens.
Figure 3-1 Control Surface Configuration dialog
2. Select Euphonix from the Use drop-down menu.
You will see the Euphonix logo with the message in Figure 3-1.
3. Press OK.
The Artist media controllers connect and update automatically. When you
open your audio mixer your Euphonix media controller(s) will control Final
Cut Pro.
Your Artist media controller should now be controlling your application. If not,
make sure Final Cut Pro is the front-most application (i.e., the one receiving key-
strokes and mouse clicks). The Artist media controllers control only the front-
most application.
To Next Page
Loading...
