Euphonix System 5 Control Surface/Frame - Power on Sequence; Ce;Tuv;Ul;Csa

S5 Control Surface/Frame Manual Page 5 Version 1.0 ©1999 Euphonix, Inc.
a) Objects have fallen, or liquid has spilled into the Control Modules;
or
b) A Control Module does not appear to operate or exhibits a marked
change in performance; or,
c) A Control Module has been dropped or sustained other physical
damage.
7) Servicing – Do not attempt to service the Control Modules beyond those
means described in this operation manual. All other servicing should be
referred to the Euphonix Tech Support department.
8) Fuse replacement – To prevent electric shock and avoid risk of fire, replace
fuse only with the same type and rating.
9) To prevent electric shock, do not use the Control Modules polarized plug with
an extension cord, receptacle or other outlet unless the blades can be fully
inserted to prevent blade exposure.
10) Grounding or Polarization – Do not defeat the grounding or polarization of
the Control Modules.
Power On Sequence
The Control Surface modules are powered up by a switch on the back of the frame.
The Control Surface should be powered up after the Virtual Mixer is running.
CE/TUV/UL/CSA
CE documentation is available.