Space User Guide The Basics
8
Using Preset Mode
In Preset Mode the Billboard displays the current Preset Number and Name. If the Preset is
Active (not Bypassed), the Left Footswitch LED is solidly lit.
To bypass the currently loaded Preset, press the Left Footswitch. The LED will turn OFF and
the Billboard will briefly display [BYPASS] and then display the Preset Number and Name.
Pressing the Left Footswitch again enables the Preset. The Billboard briefly displays [ACTIVE]
to indicate that the Preset is enabled.
The Middle and Right Footswitches are used to scroll through the Presets. The Middle
Footswitch decrements and the Right Footswitch increments. Notice that the Preset Number
flashes to indicate that the Preset has not yet been loaded. You must press the Left
Footswitch to load the cued preset.
Note: See System Mode for setting active Preset range and for using an AUX Switch to
increment/decrement through the Presets.
Power Up
When turns on it remembers what it was last doing and powers up in the same mode,
running the same Preset, with the same parameter values, same tempo, same system
settings, etc. With power off, relays connect ’s inputs directly to its outputs.
Can Two Presets Be Used Simultaneously?
No. When you load a Preset it runs on both channels. Presets can be used as Stereo In/Stereo
Out, Mono In/Stereo Out, or Mono In/Mono Out. is smart enough to know what
cables are connected and to automatically route the signals for your set up.
To Next Page
Loading...
