66
67
4
1
3
2
Connect infusion set
Check to ensure that the threaded
connection on the reservoir is clean.
Remove a compatible infusion set
from the packaging and connect it to
the reservoir of your pump.
Tighten the threaded connection
securely to ensure that the infusion set
does not loosen during drug delivery.
CONNECTING,
PREPARING,
AND PRIMING THE
INFUSION SET
Confirm the procedure with .
Observing and stopping the priming
cycle
Observe the infusion set during the
priming cycle. It takes a few seconds
until liquid becomes visible in the
tube. The drug solution is then slowly
pushed in the direction of the tip of the
needle.
Pump ready
Pump and reservoir are now ready for
use. If you wish to prime the infusion
set, then press
Yes .
Press
No to skip this step. The
infusion set will not be primed.
Proceed with Step 6 "Put on infusion
set".
If the infusion set connection is
not adequately tightened, it could
start leaking, leading to an i
ncorrect dose or no delivery of the
drug. Overtightening the threaded
connection can damage the
connection point.
Make sure that the connection to
the reservoir is clean and has not
been touched.
To Next Page
Loading...