evertz 5600ACO2 - Show Status

Model 5600ACO2 Automatic Changeover Unit
4.3.4. Show Status
4) Show Status – shows a synopsis of all of the above 3 items, and also shows the status of all input
channels. There are no settable controls under this menu item.
----------------------------------
Trap destinations
Trap Destination 1: 192.168.192.215
----------------------------------
Community Strings
Read-Only: |public|
Read-Write: |private|
----------------------------------
ip address: 0.0.0.0
netmask address: 0.0.0.0
gateway: 0.0.0.0
broadcast address: 255.255.255.255
DHCP enabled: True
Ethernet enabled: True
----------------------------------
Individual channel voting enabled.
In voting, I = included, E = excluded.
Sync 1 = I. Sync 2 = I. Sync 3 = I. Sync 4 = I. Sync 5 = I. Sync 6 = I.
LTC 1 = I. LTC 2 = I.
GPO 1 = I. GPO 2 = I.
Ten MHz = I. ATG = E.
Balanced AES = E. Unbalanced AES = E.
Balanced DARS = E. Unbalanced DARS = E.
SD Black 1 = I. SD Black 2 = I. SD Test Gen 1 = I. SD Test Gen 2 = I.
HD Black 1 = I. HD Black 2 = I. HD Test Gen 1 = I. HD Test Gen 2 = I.
----------------------------------
Input status. A = present on input A, a = not present on input A
B = present on input B, b = not present on input B
Sync 1 = ab. Sync 2 = ab. Sync 3 = ab.
Sync 4 = ab. Sync 5 = ab. Sync 6 = ab.
LTC 1 = ab. LTC 2 = ab.
GPO 1 = AB. GPO 2 = AB.
Ten MHz = ab. ATG = ab.
Balanced AES = ab. Unbalanced AES = ab.
Balanced DARS = ab. Unbalanced DARS = ab.
SD Test Gen 1 = ab. SD Test Gen 2 = ab. SD Black 1 = ab. SD Black 2 = ab.
HD Test Gen 1 = ab. HD Test Gen 2 = ab. HD Black 1 = ab. HD Black 2 = ab.
Power Supply 1 = Ok. Power Supply 2 = Failed.
Current output selected is A
Page 4-8
Revision 1.3 TECHNICAL DESCRIPTION