evertz 5600ACO2 - Using Vistalink to Configure the 5600 ACO2

Model 5600ACO2 Automatic Changeover Unit
5.1.3. Using VistaLINK
®
to Configure the 5600ACO2
The 5600ACO2 should be auto-discovered by VistaLINK
®
PRO and appear under the Hardware
section of the VistaLINK
®
PRO Navigation Tree named with its given IP Address. If the 5600ACO2 is
not auto-detected (because it is on another subnet) it can be manually added by right clicking the
Hardware node and selecting Add/Update frame.
Right click the discovered 5600ACO2 to open the Configuration View screen. The screen is broken
into eight tabs. To view the other screens, click on the appropriate tab of the configuration screen.
Figure 5-1 shows the Voting control screen that is used to configure how the 5600ACO2 makes its
decision about valid signals and when to switch to the backup signals.
Once you have finished configuring the 5600ACO2 items on the configuration screen you can save the
configuration in VistaLINK
®
. You can also send it to the 5600ACO2 by pressing the Apply button on the
VistaLINK
®
toolbar.
Page 5-2
Revision 1.3 VistaLINK
®
CONFIGURATION