Model 5600ACO2 Automatic Changeover Unit
3.3.8. Change Limiting....................................................................................................... 3-7
3.4. GPO TALLY OUTPUTS...................................................................................................... 3-8
4. TECHNICAL DESCRIPTION ....................................................................................................... 4-1
4.1. SPECIFICATIONS...............................................................................................................4-1
4.1.1. LTC Outputs.............................................................................................................4-1
4.1.2. Coaxial Inputs and Outputs...................................................................................... 4-1
4.1.3. Balanced DARS, AES and Analog Audio Inputs and Outputs................................. 4-1
4.1.4. ACO General Purpose Inputs and Outputs..............................................................4-1
4.1.5. MSC General Purpose Inputs and Outputs ............................................................. 4-2
4.1.6. Changeover Conditions ........................................................................................... 4-2
4.1.7. Ethernet ...................................................................................................................4-2
4.1.8. Electrical ..................................................................................................................4-2
4.1.9. Physical.................................................................................................................... 4-2
4.2. UPGRADING THE FIRMWARE.......................................................................................... 4-3
4.2.1. Overview..................................................................................................................4-3
4.2.2. Terminal Program Setup.......................................................................................... 4-3
4.2.3. Initiating Firmware Upgrade Mode From The Terminal Program.............................4-3
4.2.4. Uploading the New Firmware................................................................................... 4-4
4.2.5. Completing the Upgrade..........................................................................................4-4
4.3. SERIAL PORT CONFIGURATION AND STATUS ............................................................. 4-4
4.3.1. Network Configuration ............................................................................................. 4-6
4.3.2. SNMP Configuration ................................................................................................ 4-6
4.3.3. Voting Control .......................................................................................................... 4-7
4.3.4. Show Status.............................................................................................................4-8
4.4. SERVICING INSTRUCTIONS............................................................................................. 4-9
4.4.1. Changing the Fuses................................................................................................. 4-9
5. VISTALINK
®
CONFIGURATION AND CONTROL....................................................................... 5-1
5.1.1. Connecting the 5600ACO2 to VistaLINK
®
............................................................... 5-1
5.1.2. Installing VistaLINK
®
................................................................................................ 5-1
5.1.3. Using VistaLINK
®
to Configure the 5600ACO2........................................................ 5-2
5.1.4. Using VistaLINK
®
to Monitor the 5600ACO2............................................................ 5-4
5.1.5. Using VistaLINK
®
to Enable the Fault Reporting Traps of the 5600ACO2............... 5-6
Page ii
Revision 1.3 CONTENTS