evertz hd9084 - Port X Setup (X= A,B,C,D,E,F); Port X Mode; Table 3-3: Port Mode Options

HD9084 HDTV Caption Encoder Manual
OPERATION Page 3-29
The Ports Menu allows the user to configure the input/output settings of Ports A through F. Ports A, B,
and C are RS232/422 serial ports, Ports D and E (optional) are telephone modems, and Port F is a
telnet server via the Ethernet port. Please refer to section 2.1 for rear panel layout.
To enter the Ports Setup Menu, press PORTS then SETUP. Use the UP and DOWN arrow
pushbuttons to scroll through the different options as listed in sections 3.6.1 to 3.6.3. Refer to the
diagram below to view a “quick reference” layout of the Ports menu system. To exit the menu system,
press SETUP until the MENU LED is off.

For more information on “MSG. INJECT GPI” and “MSG. INJECT CCx” menu items,
please refer to section 4.7.
3.6.1. Port x Setup (x= A,B,C,D,E,F)
Port x Setup allows the user to set the mode, baud, and communication separately for each port. To
enter the Port x Setup sub-menu, use the UP and DOWN arrows until Port x Setup is displayed on the
front panel. Press SELECT to enter the sub-menu. The following options are available in the Port x
Setup sub-menu. To see a “quick reference” layout of the menu system, please refer to section 3.6.
Press SETUP to exit this level.

Port E exists if +MDM2 option is ordered. Port E functions the same as Port D.
3.6.1.1. Port x Mode
Port x Mode configures the output of Ports A through F. The following is a list of the available settings:
PORT
Port A
Port B
Port C
Port(s) D, E, F
OUTPUT
 Control A
 Echo Port B
 Echo Port C
 Echo Port D
 Echo Port F
 608 Xmit Out
 CDP Xmit Out
 Control A
 SMPTE – 333M Out
 G. Alliance Out
 Echo Port A
 Echo Port C
 Echo Port D
 Echo Port F
 608 Xmit Out
 CDP Xmit Out
 Control A
 Dobly Meta In
 Echo Port A
 Echo Port B
 Echo Port D
 Echo Port F
 608 Receive In
 608 Xmit Out
 CDP Receive In
 CDP Xmit Out
 Control A
Table 3-3: Port Mode Options
To enter the Port x mode option, use the UP and DOWN arrows until Port x Mode is displayed on the
front panel. Press SELECT to enter this option. The user can now choose the output of the port using
the UP and DOWN arrows. Press SELECT to enable the setting. The enabled setting will flash. Press
SETUP to exit this level.
USO RESTRITO