HD9084 HDTV Caption Encoder Manual
OPERATION Page 3-37
3.8.1. Load Preset
To load a desired preset, enter the General Setup menu and scroll to LOAD PRESET using the UP and
DOWN arrow pushbuttons. Press SELECT to enter the LOAD PRESET option and use the UP and
DOWN arrow pushbuttons to scroll through the presets. Choose which preset you would like to load
and press SELECT. The preset is now loaded. To save presets, please refer to section 3.8.2.
3.8.2. Store Preset
To store a preset, first set the HD9084 to the desired settings. Enter the General Setup menu and
scroll to the STORE PRESET option using the UP and DOWN arrows. Press SELECT to enter the
STORE PRESET option and use the UP and DOWN arrow pushbuttons to choose a number to store
the preset. Once a preset number is chosen, press SELECT to store the preset configuration to the
desired number. A maximum of 4 presets can be stored. To load the saved presets, please refer to
section 3.8.1. Press SETUP to exit this level.
The HD9084 is constantly monitoring the state of the system. When the user selects a particular
configuration, the settings are written into flash memory. If a power outage occurs, the settings are
automatically restored upon power up. The user may erase the flash by executing a factory reset. See
section 3.8.3.
The user must exit out of the menu system in order for the changed settings to
be stored into flash memory.
3.8.3. Factory Reset
The Factory Reset option is used to set the HD9084 back to the factory default setting. To reset the
HD9084, enter the general menu and use the UP and DOWN arrow pushbuttons to scroll to the
FACTORY RESET option. Press SELECT to enter the FACTORY RESET option. To reset the unit,
the user must press SHIFT + SELECT in order to reset the unit to factory settings. Press SETUP to
exit this level.
3.8.4. Erase NV XDS
The Erase NV XDS option removes XDS articles from memory. These articles would be stored in
memory during a power loss. To clear the memory of articles, use the UP and DOWN arrows until
Erase NV XDS is displayed on the front panel and press SELECT. The front panel will instruct the user
to press SHIFT + SELECT to complete the process. Press SETUP to exit this function.
3.8.5. Network Setup
The Network Setup menu has five network parameters that need to be configured for network use.
The HD9084 network port is used to ingest control-A caption data via a telnet
connection.
To Next Page
Loading...
