Evident DP75 - Proper Selection of the Power Supply Cord

DP75
If no power supply cord is provided, please select the proper power supply cord for the equipment by
referring to “Specifications” and “Certified Cord” below:
Caution : In case you use a non-approved power supply cord for our products, we can no longer
warrant the electrical safety of the equipment.
Specifications
Voltage rating
Current rating
Temperature rating
Length
Fittings configuration
125 V AC (for 100-120 V AC area) or, 250 V AC (for 220-240 V AC area)
6 A minimum“60 ˚C minimum
3.05 m maximum
Grounding type attachment plug cap. Opposite terminates in molded-
on IEC configuration appliance coupling.
Table 1 Certified cord
A power supply cord should be certified by one of the agencies listed in Table 1 , or comprised of cordage
marked with an agency marking per Table 1 or marked per Table 2. The fittings are to be marked with at
least one of the agencies listed in Table 1. In case you are unable to buy locally the power supply cord
which is approved by one of the agencies mentioned in Table 1, please use replacements approved by any
other equivalent and authorized agencies in your country.
Country Agency Certification
mark
Country Agency Certification
mark
Argentina IRAM Italy IMQ
Australia SAA Japan JET
Austria ÖVE Netherlands KEMA
Belgium CEBEC Norway NEMKO
Canada CSA Spain AEE
Denmark DEMKO Sweden SEMKO
Finland FEI Switzerland SEV
France UTE United
Kingdom
ASTA
BSI
Germany VDE U.S.A. UL
Ireland NSAI
14. Proper selection of the power supply cord
37
14. Proper selection of the power supply cord