Evident DP75 - Electrical Safety; Injury Prevention; Preventing Burn

DP75
Keep the power cord and cables well away from the lamp house
If the power cord or cables gets in contact with the high temperature part of the lamp house, the cord may melt,
which could result in an electric shock.
2.4 Electrical safety
CAUTION:
Always use the AC adaptor and the power cord provided by our company
If the proper AC adapter and the power cord are not used, the electric safety and the EMC (Electromagnetic
Compatibility) performance of the product intended by our company cannot be guaranteed.
The product must be grounded
Connect the ground terminal of the power cord to the ground terminal of the power outlet.
If the product is not grounded, our intended electrical safety and EMC performance cannot be guaranteed.
Do not use the product in close proximity to sources of strong electromagnetic radiation
Proper operation may be disrupted. The electromagnetic environment should be evaluated prior to operation of
the product.
Disconnect the power cord in case of emergency
In case of emergency, disconnect the power cord from the power cord connector on the product or from the
power outlet.
Install the product at the location where you can reach the power cord connector or the power outlet at hand to
disconnect the power cord quickly.
While the power is ON, do not connect or disconnect the power cord, cables, or attach/detach the unit
2.5 Injury prevention
CAUTION:
Do not touch sharp parts of the product
Do not touch the C mount thread because it has sharp edges. Otherwise, you may get injured.
Install the product securely
Screw the C mount camera adapter in to the camera head firmly.
If it is attached loosely, the camera head may drop while in use, causing potential injury.
Do not drop the IR cut filter slider
When removing the IR cut filter slider, take care not to drop it.
The glass of the IR cut filter slider may be broken by dropping it and you may get injured with broken pieces.
Do not put cables on the floor
If you put the cables on the floor, your feet may get caught in the cables, causing the microscope system to tip
over, which may cause the product to break down or the user to get injured.
Run the cable along the wall or place it behind the microscope system so that you can avoid tripping over it.
2.6 Preventing burn
CAUTION:
5
2.4 Electrical safety2. Safety Precautions