Please use the product in accordance with this instruction manual. If the product is used in a manner not specified
manufacturer, the protection provided by product may be impaired. And it may also cause the malfunction of this
product.
2.1 General
NOTE:
This product is a precision instrument. Handle it carefully and avoid impact on it.
Disassembling the product could cause unexpected accidents or malfunctions. Never disassemble the
product.
Do not use the product in areas where it may be exposed to direct sunlight, high temperature and/or
humidity, dust or vibrations.
(For information about the conditions of operating environments, please refer to “Specifications” (page 32)).
The power cord included is for this product only. It cannot be combined with other products.
Before disposing of this product, be sure to follow the regulations and rules of your local government.
2.2 Installation
CAUTION:
Place the product on a sturdy, level table
For safety reasons in particular, do not place a mat, etc. under the product.
Avoid making the total height of the product higher than 1 m
To prevent the product from falling, avoid a system configuration that makes the total height of the product
higher than 1 m.
Be careful not to drop the product when installing/removing the product
Dropping the camera head and C-mount camera adapter may damage the product or cause injury.
2.3 Electric shock prevention
WARNING:
Never disassemble this product
This could cause electric shock or product failure.
Do not touch the product with wet hands
In particular, if you touch the main switch of the power unit or the power cord with wet hands, this could cause
electric shock, fire, or product failure.
Do not insert tools or pieces of metal into the air vents of the product
This could cause electric shock or product failure.
Do not bend, pull, or tie up the power cord or cables
Otherwise they could be damaged, causing a fire or an electric shock.
2. Safety Precautions
4
2. Safety Precautions 2.1 General
To Next Page
Loading...