4. ASSEMBLING THE RIP FENCE
The rip fence guide has an adjustable aluminium faceplate.
For normal use this should be attached to the steel carrier
of the rip fence with the deep (60mm) side in the vertical
position and on the LH side of the carrier. See Fig 9.
1. Place the two ø6mm x 60mm dome headed coach-bolts into
the two through holes in the carrier, dome heads to the LH side.
2. Put washers and the finger nuts (by only
a couple of threads) onto the RH side of the carrier.
3. Slide the aluminium faceplate onto the bolt heads.
4. Tighten the two finger nuts.
Note: The magnifier in the Rip Fence clamp should be visible.
5. THE FENCE RAIL
Note: The Fence Rail is supplied in two pieces which slot
together. The metal locating bar should be inserted into the
rectangular voids of the two extrusions to bridge both parts
of the fence rail. The bar should be equally located in either
side of the fence rail. See Fig 10. The six ø6mm x 15mm
domed headed coach bolts should be slid into the channel
at the back of the Fence Rail.
1. Offer the Fence Rail up to the front of the machine.
2. Position the six bolts to align with the six holes (one in each
extension and four in the main aluminium table). See Fig 11.
3. Attach the Fence Rail to the machine using
washers and ø6mm nuts. Hand tighten only.
ADJUSTING
WARNING: The machine must not be connected to its
mains supply when carrying out the following procedure.
The Fence Rail needs to be positioned correctly
for its scale to read accurately.
Fig 9
Fig 10
Fig 11
To Next Page
Loading...
