EWM LP-XQ - Programs (P a 1-15); Selection and Adjustment

Functional characteristics
MIG/MAG welding
30
099-5TLPXQ-EW501
29.01.2021
5.2.7 Programs (P
A
1-15)
Different welding jobs or positions on a workpiece require different welding programs (operating points).
The following parameters are stored in each program:
• Wire feed speed and voltage correction (welding power)
• Operating mode, welding type and dynamic
5.2.7.1 Selection and adjustment
Figure 5-13
The user can change the welding parameters of the main programs with the following components.