EWM LP-XQ - Selection Option - Program Sequence with Welding Power Rotary Knob (P30); 5.10.2 Reset to Factory Settings

Functional characteristics
Special parameters (advanced settings)
64
099-5TLPXQ-EW501
29.01.2021
5.10.1.27 Selection option – Program sequence with welding power rotary knob (P30)
Function not active
• The rotary knob is locked, use the welding parameters push-button to select the welding parameters.
Function active
• Rotary knob can be used to select the welding parameters.
5.10.2 Reset to factory settings
All special parameters saved by the user will be overwritten by the factory settings!
+
Figure 5-49