Exakt 35 - User Manual

Questions and Answers

T
thomasliAug 4, 2025
What to do if Exakt Power Tool rollers do not turn?
- E
  Eric PerezAug 4, 2025
  If the rollers of your Exakt power tool aren't turning, several factors could be at play. First, ensure the unit is properly plugged into a power supply and check the breakers. For EXAKT 50 models, a tripped circuit breaker might be the cause; wait a minute and then depress the circuit breaker. If you have an EXAKT 35, the motor may have overheated, so wait an hour before switching it on again. Also, check for any foreign matter between the rollers and remove it. If these steps don't resolve the issue, there may be a defective drive belt, reducing gear, or a faulty ON/OFF switch.
B
Benjamin MillerAug 10, 2025
What to do if Exakt Power Tool product is not scraped properly?
- M
  Mr. Timothy MitchellAug 10, 2025
  If the product isn't being scraped properly by your Exakt Power Tool, it might be due to a worn scraper knife. You can turn the scraper knife around or replace it. Another potential cause is insufficient contact pressure of the scraper system; in this case, increase the contact pressure.
S
schmidtjaimeAug 16, 2025
Why is Exakt Power Tool product removed on one side only?
- J
  jeffcurryAug 16, 2025
  If the product is being removed on one side only by your Exakt Power Tool, it could be due to a scraper system that isn't straight, is not flush with roller, or is installed incorrectly; re-install the scraper system correctly. Also, the scraper pins or socket might be dirty; clean the scraper holder and install the scraper system correctly.
N
nicholas49Aug 22, 2025
How to resolve diminishing product fineness in Exakt Power Tool?
- C
  Carl CervantesAug 22, 2025
  If you notice diminishing product fineness with your Exakt Power Tool, it may be due to damaged rollers or an incorrect roller gap adjustment.
T
teresa10Aug 28, 2025
What to do if product flows under the guides of Exakt Power Tool?
- J
  jjohnsonAug 28, 2025
  If product flows under the guides of your Exakt Power Tool, the guides may be worn or dirty. Clean or replace the guides.