Operation
18
Edition 04/09.2002 EXAKT 35 / 50
6.4 Adjusting the fineness of dispersion and the material throughput
The roller gap can be adjusted using two hand-wheels located
on the right side of the housing.
The uniformity of dispersion and the material throughput are
adjusted by varying the roller gap.
Note
!" Do not operate the unit without any product. This decreases
the life of the scraper.
!" Remove the hand-wheel for manual roller rotation switching
on the unit.
Position !
Smallest roller gap = finest dispersion =
lowest material throughput
Position !!
Medium roller gap = medium dispersion =
medium material throughput
Position !!!
(The hand-wheel can be rotated beyond
the position !!!)
Largest roller gap = coarse dispersion =
highest material throughput
Fig. 11: Adjusting the fineness of dispersion and the
material throughput
To Next Page
Loading...
