Operation
EXAKT 35 / 50 Edition 04/09.2002
19
Adjusting the material throughput:
!" Set the minimum roller gap (position !) for both roller gaps
when using the unit for the first time.
Note
Before attempting to process product EXAKT unit, first process
a small quantity of Vaseline or similar grease to become familiar
with adjusting the material flow.
Note
If the product to be processed is extremely viscous, sticky or
poorly pre-mixed a slightly wider roller gap is recommended for
the initial run. Subsequent processing runs can be made with a
narrower gap to improve fineness of dispersion.
Increasing the material throughput:
!" Slightly increase the front roller gap by turning the front
hand-wheel.
!" Slowly increase the rear roller gap turning the rear hand-
wheel until the product flow on the front roller covers the
entire width between the guides.
Continue to adjust the roller gaps until the optimum flow is
reached.
To Next Page
Loading...
