Exakt 35 - Checking; Cleaning and Replacing the Scraper System; Replacing; Installing the Scraper Knife Made of Metal; PVC; Epoxy Resin (EXAKT 50 Only)

Maintenance
28
Edition 04/09.2002 EXAKT 35 / 50
7.4 Checking / cleaning and replacing the scraper system
If the scraper system is worn or dirty, the product will not be
properly removed from the roller.
Check the scraper system for dirt and signs of wear after use
and whenever the product is changed:
!" Clean the dirty scraper system.
!" Replace any worn scraper parts (scraper knife).
7.4.1 Replacing / installing the scraper knife made of metal / PVC / epoxy resin (EXAKT 50
only)
The following section is a description of the steps necessary for
replacing / installing the scraper knife made of metal / PVC /
epoxy resin for the universal scraper system.
Warning – Risk of severe damage to the rollers from sharp,
serrated edges on the scraper knife!
Sharp, serrated edges on the scraper knife may scratch the
roller surface.
De-burr and smooth the scraper knife prior to installation using
a file or grindstone.
Note
The front edge of new scraper knives is already sharpened at
the factory and the knives can be installed in any position.
There is no “front” or back” the knife.