SCPI Command Reference (FTBx-9150/FTBx-9160 Only)
Optical Switch 101
Product-Specific Commands—Description
The <AutoAdjust> response represents the
current state of the <Optimize for repeatability>
option, where:
1, <Optimize for repeatability> option is
selected.
0, <Optimize for repeatability> option is not
selected.
Example(s) ROUT:SCAN:ADJ:AUTO 0
ROUT:SCAN:ADJ:AUTO? returns 0 (optimization
for repeatability is not selected).
ROUT:SCAN:ADJ:AUTO 1
ROUT:SCAN:ADJ:AUTO? returns 1 (optimization
for repeatability is selected).
See Also ROUTe[1..n]:SCAN:ADJust
ROUTe[1..n]:SCAN:ADJust:AUTO
:ROUTe[1..n]:SCAN:ADJust:AUTO?
To Next Page
Loading...