Exmark VANTAGE S Series - RH Motion Control Handle Position and Caster Pivot Bearing Adjustment

Maintenance
AdjustRHMotionControl
HandlePosition
Ifthemotioncontrolleversdonotalignhorizontally,
adjusttherightsidemotioncontrollever.
Note:Adjustthehorizontalalignmentbeforethe
fronttobackalignment.
1.Stopengine,waitforallmovingpartstostop,and
removekey.Engageparkingbrake.
2.Pushtherightmotioncontrolleverdownoutof
thePTOdisengageposition.
3.Checkiftherightmotioncontrolleveraligns
horizontallywiththeleftmotioncontrollever.
Figure34
1.LHMotioncontrollever
2.RHMotioncontrollever
3.RHMotioncontrolleverinPTOdisengageposition
4.Checkthehorizontalalignmenthere
4.Toadjusttherightmotioncontrollever
horizontally,thecamneedstobeadjusted.
5.Releasethecushionfromtherearofthemachine.
6.Loosenthenutholdingthecam(seeFigure35).
Figure35
1.Cam
2.Nut
7.Adjustthecamuntilitalignswiththeleftmotion
controlleverandtightenthenutforthecam.
Note:Movingtheatportionofthecam
clockwiselowersthehandle,whilemovingit
counterclockwiseraisesthehandle
Important:Makesuretheatportionofthe
camdoesnotgoaboveaverticalposition
(rightorleft),ordamagemayoccurtothe
switch.
8.Tightentheswitchscrews.
CasterPivotBearings
Pre-LoadAdjustment
Removedustcapfromcasterandtightennylocnut
untilwashersareatandbackoff1/4ofaturn
toproperlysetthepre-loadonthebearings.If
disassembled,makesurethespringdiscwashersare
reinstalledasshowninFigure36.
40