Extraflame DIVINA Use And Maintenance Manual

27
To light the stove, press both buttons P3 and P5 at the same time for 3 seconds (fig. 21); the stove will
automatically enter the starting stage and the display
D1 will show all the information described in
chapter 10, points 2 and 3.
After the lighting phase, follows the starting phase allowing the stove to develop and to settle the flame.
When the lighting stage is completed, the stove enters the normal operation and the heating power
can be adjusted by means of the buttons
P5 (increase heating) and P4 (decrease).
The required room temperature can be +/- adjusted by pressing
P3 or P2.
To turn off the stove, press both buttons P3 e P5 at the same time for three seconds. The display D1 will
show the message “
Off”.
The r
emote control works with a battery of the MN21 12 volt type (the kind used for gate openers).
27
FOR REMOVING THE BATTERY, FOLLOW
THESE OPERATIONS
:
• Insert a screwdriver as per drawing and
turn it in a clockwise direction.
• Once the cover up, take it away with the
fingers and remove the batteries.
Once finished, the batteries
must be removed from
the remote control, and
thrown in the due containers.
12 ROOM THERMOST
12.1 Digital thermostat
The stove can control the room temperature by means of a digital thermostat whose function is
to lower the heating power to the minimum when a pre-set temperature is reached.
1. When the stove has been started and it has entered the normal operating mode, a number (f.i.
21 C) appears on the display D1; this value indicates the room temperature.
2. The thermostat is set by pressing the button 2 and 3. A message will appear on the display
which alternates the word
“set” with the temperature to set every time one of the buttons is
pressed; the value is reduced by pressing
2 and increased by pressing 3.
3. When you have adjusted the desired temperature, wait until the message
“set” disappears
from the display.
4. The desired heating power is adjusted by means of the buttons 4 and 5.
When the stove reaches the set temperature it automatically goes to the minimum operating
condition and the
LED 1 on the display D1 will go off.
In case you wish to exclude the functioning of the digital thermostat, set, through button 3, set the
temperature to max till when on the display D1 the message “
Hot” will appear.
The same functions can be obtained by means of the remote control.

Extraflame DIVINA Specifications

General

Brand	Extraflame
Model	DIVINA
Category	Stove
Language	English