31
13 CHRONOTHERMOSTAT
This function enables you to program 2 ignitions and 2 extinctions on all the days of the week.
The ignition and extinction times will be included within a daytime, from 0 to 24, and cannot
overlap on more days:
Ex. Ignition 07:00 / Extinction 18:00 OK
Ignition 22:00 / Extinction 05:00 WRONG
All manual controls, made by remote control or on the display, have priority on programmed
settings.
To enter this setting, please press button
3, and while keeping it pressed, press button 5 on the
display.
On D1 you will have “OFF”, on
D2 a blinking 1.
By means of buttons 2 and 3, set
the current day of the week; on
the display D1, the following
messages will appear and will
change each time you press buttons
2 or 3.
Ex: If today is TUESDAY, Day2 will be set on the display.
Once you set the day, you are going to set the current hour. Press button
5 again. On the display,
the message
“00:” will appear.
By means of buttons
2 and 3, set the current hour, then press 5 again.
“:00” will appear, to be set.
If all operations have been carried out correctly, you will have set the current day and time on the
stove.
Please, press
5 again, on the display “00” will be displayed.
N.B: This parameter was meant for the Technical Assistance Service and must not be changed,
as it could compromise the correct functioning of the stove.
Please, bring it back to “00” if you change it by mistake.
Press button 5 again to carry on. The message “07:00” will appear on D1.
You are going to decide here what time you want the stove to light, by means of buttons 2 and 3.
Once you press button
5 again, you are going todecide what time you want the stove to stop, by
means of buttons
2 and 3.
After pressing button
5, you are going to decide on what days of the week you want the stove to
respect the ignition/extinction time you have just set.
On the display
D1, you will have “OFF1”, meaning that the chronothermostat will be off on
Monday. By pressing button
1, “OFF1” will become “ON1”, activating the chronothermostat on
Monday.
This procedure must be carried out by going through all the day of the week by pressing button
3 and choosing on what days the stove must light/stop according to the phase you just entered.
By pressing button
5, a second lighting-time will be shown. As described above, it is possible to
set 2 different working-phases.
To activate the second one, you have to repeat the same steps as described so far.
N.B: When the chronothermostat is active, this will be displayed one of these 2 ways:
• Display
➠
Some blinking lines forming a sort of square will flash on D1.
• Display with leds
➠
the chronothermostat pilot light will be on (see display description).
To Next Page
Loading...
Need help?
General
