48
The fire burns a weak orange
flame. The pellets pile up in the
burn pot and the door glass gets
dirty.
1. The air for the combustion is
not enough
1.a Check that all the holes in the
burn pot are open and clean
them if necessary.
1.b Check that the pipes of the
exchanger are not clogged
and clean them if necessary.
1.c Check that the air input is not
obstructed.
1.d Check that the door rings are
still in good condition.
1.e Clean the fume extractor
casing.
1.f Get an authorized technician
to check the stove.
The fume extractor fan does not
work.
1. The stove is not powered.
2. There is no power in the control
panel.
1. Check that the plug is plugged
in and that the switch on the rear
is in Pos.1
2. Check that the fuse on the rear
has not blown.
The warm air ventilator does not
go off when the stove is turned off
and cool.
1. The temperature control is
defective ( heat probe)
1. Disconnect the plug and call an
authorized technician.
Dirt or ash around the stove. 1. The door of the stove was open
during operation.
2. The door rings are worn or
broken.
3. The connection between the
fumes extractor and the chimney
flue is not hermetic.
1. Always keep the door closed
and open it only when it is cold.
2. Change the insul. rings with new
ones which must be purchased
from our dealer.
3. Close the openings with adhesive
aluminium tape or with high
temperature silicone (resistant
up to 300°)
PROBLEM REASON SOLUTION
To Next Page
Loading...
Need help?
General
