Extreme Networks Summit X150 Series - Page 222

Chapter 5: Building a SummitStack Configuration
Summit Family Switches Hardware Installation Guide
222
To connect a SummitStack 128G/20G cable:
1 Connect the 128-Gbps connector to the VIM1-SummitStack256 module as follows:
a Holding the cable connector with the release tab on top, align the connector with the stacking
port on the VIM1 module in the Summit X650 series switch (Figure 161).
Figure 161: Connecting the 128G Connector
b Firmly press the cable connector into the stacking port until the spring latch on top of the
connector clicks into place.
2 Connect the 20G connector as follows:
a Align the cable connector with the stacking port connector on the back of the switch (Figure 162).
b Firmly press the cable connector into place on the mating stacking port connector.
c Align and tighten the retaining screws on the cable connector.
Figure 162: Connecting the 20G Connector
SH_149
ES4K037