Chapter 1: Summit Family Switches
Summit Family Switches Hardware Installation Guide
66
Figure 44: Summit X440-24t-10G Switch Rear Panel
Summit X440-24p-10G Switch
The front panel of the Summit X440-24p-10G switch (Figure 45) includes:
● Twenty-four fixed autosensing 10/100/1000BASE-T PoE+ ports (ports 1–24). In addition to 24 Gbps
of high-density copper connectivity, these ports also provide a full 30 Watts of PoE+ per port. This
switch provides a total switch PoE power budget of 380 Watts.
● Four unpopulated SFP ports (ports 21–24) that provide 4 Gbps of fiber connectivity. The SFP ports
support both 100BASE-FX and 1000BASE-X optical modules.
Ports 21 through 24 are implemented as shared ports that pair a copper port with a fiber port. For
more information about combination ports, see “Combination Ports and Failover” on page 22.
For information about SFPs, see the Extreme Networks Pluggable Interface Modules Installation Guide.
● Two unpopulated SFP+ ports (ports 25 and 26) that provide 20 Gbps of fiber connectivity
● Ethernet management port
● Serial console port implemented as an RJ-45 connector, used to connect a terminal and perform local
management
● LEDs to indicate port status and switch operating conditions
For a description of the LEDs and their operation, see “Summit X440 Series Switch LEDs” on
page 77.
Figure 45: Summit X440-24p-10G Switch Front Panel
1
SH_28
2
1 = AC power input connector
2 - Redundant power connector
1 = Ethernet management port
2 = 10/100/1000BASE-T PoE ports
3 = SFP ports
4 = Stack number
5 = Console port
6 = Combination ports
7 = SFP+ ports
SH_282
4
5
3
21
7
6
To Next Page
Loading...
