Chapter 13: Removing a Summit Family Switch from a Rack
Summit Family Switches Hardware Installation Guide
394
Removing a Summit X650 DC Power Supply
WARNING!
Be sure to disconnect all power cables before you disconnect the chassis ground wire.
CAUTION
The DC power supply may be hot to the touch; use thermal protective gloves when handling the power
supply during removal.
To remove a Summit X650 DC power supply:
1 De-energize the DC circuit.
2 Disconnect the DC power cables:
a Slide the cover off the terminal block.
b Loosen the screws that secure the cable terminals to the terminal block.
c Slide the wires out from under the captive washers.
3 Disconnect the ground wire:
a Remove the screw that secures the ground wire to the power supply.
b Move the wire away from the power supply.
4 Push the latching tab to the left as you pull outward on the handle to disengage the power supply
internal connectors (see Figure 335).
Figure 335: Removing a Summit X650 DC Power Supply
SH_113
To Next Page
Loading...
